HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Link Aggregation problem

 
sandore
Occasional Advisor

Link Aggregation problem

Hi,

I have a hp 5820 comware and 3com 4200g switches, I am trying to configure dynamic link aggregation, I enabled LACP on the two uplinks on 4200g and created the required link aggregation group on 5820 and set it to dynamic.

When I add the uplinks on 5820 side, communication with 4200G stops and no ping to switch, If I add one interface it works but when I add the second interface the problem happens.

What could be the problem.

Thanks in advance.

1 REPLY
parnassus
Honored Contributor

Re: Link Aggregation problem

Outputs of display interface and display link-aggregation verbose commands (issued on both ends and for involved LAGs and member interfaces) would be useful to start diagnosing your issue.