HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Upgrading Array

 
Ayman Altounji
Valued Contributor

Upgrading Array

Hi can anyone tell me the procedure for upgrading from a smart 221 array controller to a 3200 controller, without reinstalling the OS. Specifically what problems will i encounter when booting NT after changing the array controller. Do i need to do anything to NT before upgrading? thanks in advance.
1 REPLY
Mark Cloutier
Respected Contributor

Re: Upgrading Array

It uses the same driver for both. One problem you might have is that you will have to go into the F10 partition or boot off the Smart Start cd and run the System Configuration Utility and set the 221 as the first boot controller. Save and exit and you should be ready to go.
Nothing needs to be done in advance except for a good backup which is always recommended.
We are here for a good time, not a long time!