HPE Nimble Storage
HPE Nimble Storage
Join the HPE Nimble Storage community to access blogs and forums that allow experts and collegues to share knowledge, discuss issues and find solutions.
1845486 Members
2562 Online
110244 Solutions
New Discussion

Join the conversation with experts and colleagues

Posted to:
Original author:
I'm trying to add the download site for the HPE SCM for ESXi V8 using these instructions: https://support.hpe.com/hpesc/public/docDisplay?docId=sd00004102en_us&page=GUID-823100E4-10E9-4BE8-AD1C-3FBE21CD0656.html&docLocale=en_US and so add thi...
Posted to:
Original author:
Hi, AF40 unit with sudent high latency going from <5m to 100-150ms. Verification discover that one individual disk is reporting high read and write latency (aprox 500ms write latency) but disk is not marked as failed. There is a CLI command "...
Posted to:
Original author:
Hi everyone, I am writing because I need to expand the capacity of a Nimble HF60 array. I recall that in OCA, there was a specific section where you could enter the serial number (S/N) of the unit to see the available upgrade paths. However, I cannot...
Posted to:
Original author:
We have existing Alletra 5050 with FC enabled only in production. If we enable FC + iSCSI config, will there be any down time? What is the proper procedure? Is there a way to backup the configs just in case? CLI? How does failover works in case when...
Posted to:
Original author:
Hello, This may or may not be the correct forum for this post but please advise if there is a more appropriate one. We have around 100 VMs running on HPE DL380 servers and Alletra 6030 storage. VM disks are thin provisioned. I see Infosight collects...
Posted to:
Original author:
Hello together… I have an understanding question…. Must the ip of the quorum witness be in the Range of the replication Network? We have a direct Connection between the two rcip interfaces of the allerart and want to setup the quorum… Thank you!
Posted to:
Original author:
This script will create the rule for Nimble volumes to use the RoundRobin PSP policy and set the policy on any existing Nimble volumes. The script will take an argument of the vCenter server or the ESX host. If it is not provided it will prompt for t...
Posted to:
Original author:
With 1 gig networks it is important to tune per path settings for maximum throughput. The default of 1000 IOs per path can cause micro bursts of saturation and limit throughput. I've done a fair amount of testing and found that the best setting is to...
Posted to:
Original author:
jrich523/NimblePowerShell · GitHub Built and tested in Version 3 (v2 compatibility will be validated but it should be fine) Install Run the following line in PowerShell iex (new-object System.Net.WebClient).DownloadString(' https://raw.github.com/jri...
  • Legend
  • New MessagesNew Messages
  • No New Messages No New Messages
  • Hot TopicHot Topic
  • Replied-to Thread Replied-to Topic
  • Read Only ThreadRead-Only Topic
Top Kudoed Authors Last 30 Days
Top Solution Authors Last 30 Days