osiping problem

 
njia_1
Trusted Contributor

osiping problem

Hi

We have few identical rp3410 with OSI configured and running on LAN2. The are built by a same Ignite-UX server and for OTS configuration, NSAP is the only thing that is different.

On one of the platforms we can osiping other systems but when I tried to run the same osiping command on other platforms, I got the following error message.
"No local NET configured"

then if I run otsnet command with the network ID, osiping works fine.

any ideas.

thanks
Nan
3 REPLIES 3
Jim Keeble
Trusted Contributor

Re: osiping problem

You may need to run the swconfig on the OTS product on the freshly ignited systems to make sure all the devices files get configured properly.
njia_1
Trusted Contributor

Re: osiping problem

Does HP have a OSI traceroute utility ?
steve_b
Occasional Advisor

Re: osiping problem

It's 1o years too late, but i suspect you need to set the otsnet

Use command otsnet <NSAP with N selector set to 00>

mv36tmp#./otsnet 39756f00000000000000000001080009da804100 ****THIS IS OWN NSAP with Nsel =00

 

Are your N selectors different on the system that works without the otsnet command?

 

Then use osiping