HPE Community
Operating System - OpenVMS
1753401 Members
7177 Online
108792 Solutions
New Discussion

typo error

 
wong seng guan
Frequent Advisor

‎11-03-2006 09:26 PM

‎11-03-2006 09:26 PM

typo error

Hi Guru,

Attached below is the output of setup_async_ports.com. is that any problem occur when some typo error?

Thanks
0 Kudos
Reply
1 REPLY 1
Karl Rohwedder
Honored Contributor

‎11-03-2006 09:33 PM

‎11-03-2006 09:33 PM

Re: typo error

DCl interprets the first 4 characters only, so the command will succeed. I would encourage you though to not rely on this 'feature' and to specify all qualifiers without typos.
A SET NOON at the beginning may be of benefit on such procedures, because it would allow the procedure to continue even in case of errors, but ymmv.

regards Kalle
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.