Community
Servers - General
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

How to copy data from array via live cd or hpe utility

 
Ivan_sqr_47
Occasional Contributor

‎11-08-2018 07:00 PM

‎11-08-2018 07:00 PM

How to copy data from array via live cd or hpe utility

Hi experts.
I've problem with my raid array. My type of raid is 1+0 and one disk from this raid has fail (raid controller P420). I've changed fail disk, but when server start i see next message
"Logical driver(s ) disabled due to possible data loss.
Select F1 to continue with logical drive(s) disabled
Select F2 to accept data loss and to re-enable logical drive(s)"
I understand if I press F2, then raid controller has started procedure of rebuid array, but before this i must copy data. Unfortanatellly I haven't got conectors for SAS disk (for copy data). Has anybody know the ways how to copy data from array via livecd? mayde hpe utility have got this posibility?

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎11-09-2018 12:34 AM - edited ‎11-09-2018 12:36 AM

‎11-09-2018 12:34 AM - edited ‎11-09-2018 12:36 AM

Re: How to copy data from array via live cd or hpe utility

Without pressing F2 the LD will remain disabled, so you cannot copy anything.

Your only choice is to press F2.

 

If you only swapped the bad disk, your data will be there.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.