HPE Community
Servers - General
1753830 Members
9273 Online
108806 Solutions
New Discussion

IP KVM Problem

 
CA1185203
New Member

‎09-15-2004 11:29 PM - last edited on ‎11-22-2012 06:32 PM by

‎09-15-2004 11:29 PM - last edited on ‎11-22-2012 06:32 PM by

IP KVM Problem

We`ve recently bought four 0*2*16 port IP KVM switches. However I can connect to none of them via serial cable with hyperterminal.
The conditions are the follows: 9600 bit,8 data, 1 stop, no parity, flow control none
It was working on the 1*16 port switches in the past with the same serial port conditions.
Serial cable: xxxxxxxxxx
What could be the problem?
Thanks,

Krisztian

 

 

 

P.S. This thread has been moved from Servers > Appliance Servers to Servers > general - HP Forums Moderator

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.