HPE Community
Switches, Hubs, and Modems
1753641 Members
5047 Online
108798 Solutions
New Discussion

Aruba 2530 cannot set time in web interface

 
Fortheadingley
Visitor

‎07-09-2021 02:10 AM

‎07-09-2021 02:10 AM

Aruba 2530 cannot set time in web interface

Hi,

As the subbject suggests, for the life of me I cannot find how to set the time on my Aruba 2530's using the web interface.  Can this actually be done? 

Regards

1 person had this problem.
2 REPLIES 2
parnassus
Honored Contributor

‎07-09-2021 04:10 AM

‎07-09-2021 04:10 AM

Re: Aruba 2530 cannot set time in web interface

Not totally sure but I believe it's not possible on Traditional/Advanced GUIs.

If I were you I will not waste my time with the GUI, setup a SSH session (or Console) and go in configure mode to setup ntp.


I'm not an HPE Employee
Kudos and Accepted Solution banner
0 Kudos
akg7
HPE Pro

‎07-12-2021 12:15 AM

‎07-12-2021 12:15 AM

Re: Aruba 2530 cannot set time in web interface

Hi @Fortheadingley,

I agreed with @parnassus, its not possible to change via traditional or advanced GUI.

Its better to update via cli.

Thanks!

 

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.