HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem in EMC PowerPath on HP unix

 

Problem in EMC PowerPath on HP unix

Hi everyone,
I need some help in EMCPP on HP 11.23.
Assigned some disks from Clariion to my HP machine.Then installed the EMCPP 5.1 on the machine.Rebooted the machine.While booting,it gives the message as "Starting EMC Powerpath" and then just hangs.
I removed the FC cables from the machine and hardbooted the machine,then it came up properly.
Has anyone seen this issue ?

Thanks in advance.
3 REPLIES
Steven E. Protter
Exalted Contributor

Re: Problem in EMC PowerPath on HP unix

Shalom,

Check /etc/rc.log

/var/adm/syslog/syslog.log

EMC may have its own little log file.

There must be a message.

swlist -l product | grep -i emc

swverity EMC software from that list.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
Sharma Sanjeev
Respected Contributor

Re: Problem in EMC PowerPath on HP unix

Hi

Its a know issues in EMCPP 5.1 your machine is not in hung state, but it will take some time at the time of machine bootup while initialising EMCPP 5.1

I have seen it in so many Box it tooks 10-15 Mins atleast.

Regards
Sanjeev
Everything is Possible as " IMPOSSIBLE" word itself says I M POSSIBLE
OldSchool
Honored Contributor

Re: Problem in EMC PowerPath on HP unix

and, in a response to your other post in this topic, note the following:

"if you have a account on powerlink.emc.com

check this "Install PowerPath 5.1.0 Hot Fix 4 causes boot sequence to increase." in the knowledge base."