P408i-a Poor Performance

[r_a_shannon]

Good afternoon,

I have an ML350 Gen10 with a P408i-a

I have installed 6 x 4TB SSDs Evo Pros and configured a RAID 10.  I am getting poor read write speeds and wondered if anyone could send me the optium settings for the RAID to get the best read write performance?

[sudhirsingh]

Hi,

1. Ensure that you have enabled cache for the logical drive, if not enter into Smart Storage Admininistrator(SSA) and enable cache for the logical drive.

2. let the read/write ratio be default (10% Read / 90% Write ) although you can change it.

3. Also please check the stripe/block size if you have selected, i would say let it be default as well (set to 8/16KB unless you have specific requirment)ok

one final recommendation, for better performance you should ise SAS drives.

Hope this helps!

Regards,

Sudhir