HPE Community
Array Setup and Networking
1825006 Members
2746 Online
109678 Solutions
New Discussion юеВ

Change the IP Address from my Nimble

 
Felipe Martinez
Frequent Advisor

тАО10-12-2021 09:30 AM - last edited on тАО10-12-2021 10:43 AM by

тАО10-12-2021 09:30 AM - last edited on тАО10-12-2021 10:43 AM by

Change the IP Address from my Nimble

Hello:

We are rearranging our data center and need to move our Nimble AF40 to a new network segment (different IP and GW), any idea about the best way to do this?

0 Kudos
Reply
2 REPLIES 2
Sheldon Smith
HPE Pro

тАО10-12-2021 09:38 AM

тАО10-12-2021 09:38 AM

Re: Change the IP Address from my Nimble

A call to Nimble Support would be the best way. 

Create and edit a Netconfig Draft.

  1. Set new subnet IPs, netmask?
  2. Set new subnet gateway.
  3. Double-Check everything.

Validate the draft.

  1. Double-Check everything.

Make Draft Active.


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

0 Kudos
Reply
mamatadesaiNim
HPE Blogger

тАО10-12-2021 12:52 PM

тАО10-12-2021 12:52 PM

Re: Change the IP Address from my Nimble

Adding on to Sheldon's reply: keep in mind - changes will be needed on all hosts connected to the storage array since IP and GW are changing.  Please refer to host-side best practices.

HPE Nimble Storage
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.