BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Change ilo subsystem name from cli

 
SOLVED
Go to solution
Highlighted
Occasional Contributor

Change ilo subsystem name from cli

Hello is there way of changing the ilo subsystem name from the virtual connect console or the ilo cli.

I have been unable to find a method of doing this.

Thank you
Steve
4 REPLIES 4
Highlighted
Honored Contributor
Solution

Re: Change ilo subsystem name from cli

Just tried this on a BL460c G6 iLO CLI, seems to work:

hpiLO-> cd /map1/enetport1
hpiLO-> set SystemName=gaga
status=0
status_tag=COMMAND COMPLETED
Network settings change applied, iLO needs to be reset.
CLI session stopped
Highlighted
Honored Contributor

Re: Change ilo subsystem name from cli

Hi Steve,

That works if you telnet or SSH to the ilo IP address. You can also do this from a telnet or SSH connection to the Onboard Administrator using the HPONCFG command. Read the guide here for more info:
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00294268/c00294268.pdf

good luck, points are appreciated if these answers help!
Highlighted
Occasional Contributor

Re: Change ilo subsystem name from cli

Thank you for the answers.

Michael yours was exactly what I was looking for.

WFH-WI did donwnload the pdf pervious to my post but could not find the values to change.

Thank you both for your help
Highlighted
Honored Contributor

Re: Change ilo subsystem name from cli

hi Steve,

Sorry for the delay in responding. You should use the MOD_NETWORK_SETTINGS section and the DNS_NAME value in RIBCL to modify the ilo subsystem name using HPONCFG. For example, telnet to your OA and run:

HPONCFG <<&&









&&

Hope that helps!