Multiple Shared Uplink Sets using HP 1/10Gb VC-Enet Module?

[ejlion]

Is it possible/permitted to set up Multiple Shared Uplink Sets using the HP 1/10Gb VC-Enet Module?

For example, to have ports 1 and 2 in one shared uplink set, and 3 and 4 in another?  Or is this a limitation of some sort?

The interface allows this, but I wannot get ports 3 and 4 to communicate outside the chassis*, and this has now happened on two chassis.  I've tried multiple configurations and repeated the setup to rule out human error, fat-finger, etc.

The uplink. configuration has been verified using other hardware.

Any advice or insight would be appreciated.

Thanks.

* - servers attached to it can reach one another - they just can't reach anything outside the chassis.

[Steven Clementi]

You can certainly create more than one Shared Uplink Set with the ports available on the VC Module.  You can even create a Shared Uplink Set with no ports assigned to it. The ony thing you cannot do is add the same ports to multiple SUS's.

[Psychonaut]

What does you SUS look like?  Do you have some screen shots to share?