HPE Community
BladeSystem - General
1848586 Members
3445 Online
104033 Solutions
New Discussion

Re: Stacking Link FAILED

 
Jafiz Nazim
Occasional Advisor

‎07-29-2009 08:59 PM

‎07-29-2009 08:59 PM

Stacking Link FAILED

One of my c3000 VC staking link status is showing as FAILED and Redundancy Status:No Redundancy.

Could any one pls help me to fix this issue.
0 Kudos
Reply
6 REPLIES 6
JKytsi
Honored Contributor

‎07-29-2009 10:03 PM

‎07-29-2009 10:03 PM

Re: Stacking Link FAILED

You have only one VC module ?
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
Jafiz Nazim
Occasional Advisor

‎07-29-2009 10:07 PM

‎07-29-2009 10:07 PM

Re: Stacking Link FAILED

1 have two VC'c
0 Kudos
Reply
JKytsi
Honored Contributor

‎07-30-2009 01:40 AM

‎07-30-2009 01:40 AM

Re: Stacking Link FAILED

well ...are the modules stacked ? = connected to each other with 10Gb or 1Gb cable.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
Jafiz Nazim
Occasional Advisor

‎07-30-2009 01:44 AM

‎07-30-2009 01:44 AM

Re: Stacking Link FAILED

Yes it stacked through X0 port......
0 Kudos
Reply
JKytsi
Honored Contributor

‎07-30-2009 02:45 AM

‎07-30-2009 02:45 AM

Re: Stacking Link FAILED

and what link it says failed ? There is horizontal stacking between modules but on c3000 that's not possible (all embedded NICs go to interconnect bay1).
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
JKytsi
Honored Contributor

‎07-31-2009 09:51 AM

‎07-31-2009 09:51 AM

Re: Stacking Link FAILED

So ... ?
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.