HPE Community
BladeSystem - General
1848867 Members
6542 Online
104038 Solutions
New Discussion

Re: Virtual connect Blade Unknown

 
Aissa
Frequent Advisor

‎06-14-2010 11:33 PM

‎06-14-2010 11:33 PM

Virtual connect Blade Unknown

Hi all,

When i connect a blade 460G6 or change it from a bay to another one on the C7000 my Blades is shown as unknown.i have to restart VC so my Blades is see correctly.

Do you have any idea about that
0 Kudos
Reply
2 REPLIES 2
JKytsi
Honored Contributor

‎06-15-2010 12:42 AM

‎06-15-2010 12:42 AM

Re: Virtual connect Blade Unknown

I would start by checking FW levels
- VC
- blade (BIOS,ILO)
- OA
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
Gerardo Arceri
Trusted Contributor

‎06-15-2010 12:44 PM

‎06-15-2010 12:44 PM

Re: Virtual connect Blade Unknown

Definitely, you need a firmware upgrade According to the following document:
http://h18004.www1.hp.com/products/blades/components/c-class.html

"Note 2: If you are using G6 ProLiant server blades in an enclosure (with or without G1 or G5 server blades), you are required to upgrade to the OAv2.51 compatibility column below. Using OA v2.51 MUST have the latest ROM and iLO versions installed. "


Regards, and don't forget to assign points.!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.