dtc server

[Sarjerao]

Hi,
I have dtc rx16 server, the diag cable is missed somewhere, can u pl give pinout RJ45 to DB 9 , so that I can prepare the same

[Rajesh SB]

Hi,

You may find the pinout diagram for RJ45 to DB9 in the guide in the below link

http://docs.hp.com/en/5961-6410/5961-6410.pdf

section:
8. Making your own 8. cables . . . . . . 69

Hope this will help you.

Good Luck.

Rajesh

[Adisuria Wangsadinata_1]

Hi,

Check the thread at the url below :

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=14497

From the thread :

The DTC diag cable is 8120-6196:

...... DTC SIDE RJ45 DB25 (DTE DEVICE)
RD-INPUT ... 1 <---------- 2
TD-OUTPUT ... 3 ----------> 3
SGND ... 6 ----------- 7
RTS- OUTPUT ... 5 ----------> 8
CTS- INPUT ... 4 <---------- 22

Hope this information can help you.

Cheers,
AW

[Sarjerao]

Thanks Rajesh
do u have any doc...related to lcd codes back display.....
My server displayaing falsing 3 and fault led...

[Rajesh SB]

Hi,

Sorry, I don't have any docs related to lcd codes back display. Only I can provide some more docs related to DTC, if you need.

PS: Hope you assign some points for my useful answers :-)

Regards,
Rajesh

[Adisuria Wangsadinata_1]

Hi,

Hope you have the DTC Manager, so you can use the document below to troubleshoot the issue :

http://docs.hp.com/en/J2496-90003/J2496-90003.pdf

Hope this information can help you.

Cheers,
AW

[Sarjerao]

my dtc giving problem, when I disconnect mdp and run diag, it shows all dirct port ok, but when i connect mdp and run diag, it says modem 232 port faulty.
mdp is working ok, that i check on another dtc.
for replacing dtc wht steps need to take?
I just only given same IP address to old to new one and connected but it is not woring.

[Sarjerao]

Hello
Is there any one dtc expert, i need urgent help. Thanks.......

[Rajesh SB · Accepted solution]

Hello,

I give a try, provide the problem details.

Regards,
Rajesh

[Sarjerao]

Hi Rajesh,
my dtc giving problem, when I disconnect mdp and run diag, it shows all dirct port ok, but when i connect mdp and run diag, it says modem 232 port faulty.
mdp is working ok, that i check on another dtc.