Radius local AP

[Ert_2]

HI,

I am configuring an access point hp ap 530 and I have a problem with the authentification radius local.

I've configured a wpa 802.1x with a local radius. When I want to connect to the AP I have a message from Windows that it can't find a certificate.

How can I do to generate a certificate and to say to the AP that I use this certificate for the authentification.

In the settings we can't say anywhere that we use a specific certificate.

Do you have any ideas?

Best regards,

HER

[Matt Hobbs]

When using the built in RADIUS server, you must use PEAP-MSCHAPv2 on your clients.

Further to that, on the clients I've found that you also need to unselect any options of 'validate server certificate'

[Ert_2]

Thanks for your reply,

I did it, but it doesn't work. The system doesn't ask a certificate now, however the client can't can't connect to the AP.

[Matt Hobbs]

From your screenshots it looks like you have WPA2 set on the AP, but are using WEP on the client? First of all, make sure the client is also set to WPA2. Alternatively, change the AP to Dynamic WEP instead and try again.

[Ert_2]

Tanks a lot,

I use Dynamic Wep. It works.

[Nameesh NR]

Hi,

I am facing similar problem to the one that was discussed as part of this thread.

(1) Have configured Dynamic WEP (Radius Server)
on my Wireless 420wl AP
(2) Configured Network Authentication/Data
Encryption as Open/WEP. Also did the
similar configuration changes as mentioned.

But, the client does not get the IP address
eventhough the 420wl has been added as one
of the Radius Client.

Please let me know what I need to do for my
laptop to get the IP address.

Thanks & Regards,
Nameesh.