HPE Community
Communications and Wireless
1856587 Members
5798 Online
104113 Solutions
New Discussion

Re: WL-410

 
Jason Bischoff_1
Occasional Contributor

‎12-06-2004 12:38 PM

‎12-06-2004 12:38 PM

WL-410

I have an old WL-410 Access Point that I need to configure and use as a bridge.

Problem is, I can't get into the configuration 'AP Manager'. It comes up with the factory IP address 153.69.254.254, but I can't get any further. It asks for a new IP address, which I assign it an address withing my internal range, then it asks for the read/write SNMP string, 'public'. When I enter that, it then comes up with, this device is not an Access Point.

Any ideas or help?
0 Kudos
1 REPLY 1
Fernando D. Flores
Frequent Advisor

‎12-09-2004 05:04 AM

‎12-09-2004 05:04 AM

Re: WL-410

I found these instructions on the web maybe it can help you. Let me know if this helps you out in case I run into a WL-410
keep it simple
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.