- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- 3COM 4500-26 Port Switch
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2014 03:17 AM - last edited on 11-24-2014 04:16 AM by Lisa198503
11-19-2014 03:17 AM - last edited on 11-24-2014 04:16 AM by Lisa198503
3COM 4500-26 Port Switch
Hi all,
I just recognized that some switches have checksum issues.
When I enter the "save" command and save the configuration the switch tells me that Unit1 was successfully saved but Unit2s and Unit3s checksum is different from Unit1s and therefore, I think the it doesn't get saved correctly.
I already checked if there would a difference between the units in the configuration but it absolutely looks the same (except the client ports of course).
Currently I'm using this Firmware: V3.03.02s168p21
I was looking for a solution in the Internet but only found the same question with no real answer.
And if I found an answer, I tried it but it was not successful (for ex re-adding cipher commands).
Does someone know how to fix this without a firmware update?
Thank you,
Remo
P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Comware-Based. -HP Forum Moderator