HPE Community
Comware Based
1826568 Members
3692 Online
109695 Solutions
New Discussion

4226T problem with Cisco routers

 
Sandro_1
New Member

‎09-23-2009 03:13 PM

‎09-23-2009 03:13 PM

4226T problem with Cisco routers

My switch 4226T hanged suddenly with cisco routers atached.

I try atach 3 diferents Cisco routers in my 4226T (Two 1750 and one 805), the switch have no any special configurations (vlan, monitor, security configurations).

I try configure routers interface with half-duplex, and 10 mb speed, and configure switch port with no flow control, and no auto speed. Nothing resolves.

Any sugestion?



0 Kudos
1 REPLY 1
Fred_Mancen_1
Super Advisor

‎09-23-2009 03:43 PM

‎09-23-2009 03:43 PM

Re: 4226T problem with Cisco routers

Hi Sandro.



Try to set up the speed and duplex on both ends hardcoded; normally devices of different vendors don't negotiate well these parameters.



Regards.

Regards,
Fred Mancen
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.