GreenLake Administration
- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Alarm message Severity/decoder
Comware Based
1859568
Members
6859
Online
110403
Solutions
This widget could not be displayed.
This widget could not be displayed.
This widget could not be displayed.
This widget could not be displayed.
This widget could not be displayed.
This widget could not be displayed.
This widget could not be displayed.
Forums
Categories
This widget could not be displayed.
Company
This widget could not be displayed.
Local Language
This widget could not be displayed.
back
This widget could not be displayed.
This widget could not be displayed.
This widget could not be displayed.
back
This widget could not be displayed.
This widget could not be displayed.
This widget could not be displayed.
Blogs
Information
This widget could not be displayed.
This widget could not be displayed.
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- This widget could not be displayed.This widget could not be displayed.This widget could not be displayed.This widget could not be displayed.This widget could not be displayed.This widget could not be displayed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-18-2013 10:45 AM
05-18-2013 10:45 AM
Alarm message Severity/decoder
Hi friends,
Is there any guide available to check severity wise alarm seggregation list ( like Critical,Major,Minor,warning).
we have HP5500-24G EI switch.
Thanks,
Deep17
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
Company
Events and news
Customer resources
© Copyright 2026 Hewlett Packard Enterprise Development LP