BPDU-Drop command will delete lldp packet

[HsuLiPing]

Hi all:

My company have too many HPE 5130 HI when i use these device connect to Extreme/Cisco or Cisco ip phone 

device i found when i add bpdu-drop any comman in any interface then it will delete lldp packet that from neihor device pass lldp packet

I don't knew why that will delete lldp packet 

Is bug?

[akg7]

Hi,

CISCO supports CDP and HPE devices supports LLDP. So you need to configre CDP compatibility.

When the switch is directly connected to a Cisco device that supports only CDP rather than LLDP,
you can enable CDP compatibility to enable the switch to exchange information with the
directly-connected device.

CDP compatibility enables the switch to use LLDP to receive and recognize CDP packets from the
directly-connected device and send CDP packets to the directly-connected device.

Configuration prerequisites:

Before you configure CDP compatibility, complete the following tasks:
• Globally enable LLDP.
• Enable LLDP on the port connecting to a device supporting CDP.
• Configure LLDP to operate in TxRx mode on the port.

Commands:
#system-view
#lldp compliance cdp
#interface interface-type interface-number
#lldp compliance admin-status cdp txrx

Thanks!