Comware Sending ACL logs to Snmp Agent

[Mr_Gore]

Hello all,

I just had a question regarding the info-center and snmp-agent configuarations. Currently i have a HP 5500 Switch which has an ACL rule setup to block IP packets from a specified address. The acl works and was defined as such (Where X's are used to represent an IP address): 

rule 0 deny ip source X.X.X.X 0 destination X.X.X.X 0 logging

When i log into the web interface and look at the syslog im able to see logs that show all the traffic and acl blocks; however im not recieving any of those notifications on my snmp-agent. On the snmp agent im only getting messages from the trapbuffer (link up/down, ssh connections, web connections...etc). I was just wondering if anyone has any suggestions or ideas on how i can configure this properly; I've reffered to the manual but still seem to be having trouble with this. In the info center ive setup the TRAP, DEBUG and LOG levels to informational so i thought this should work.

info-center source default channel 5 log state on trap level debugging debug state on

Thanks again for any help.