fiber between 4200g and 4210

[shaunall]

I am trying to get a fiber connection between our 4200g and a 4210 52 port switch. both are using 3csfp91 modules. The device configuration screen shows  the connection as active, but I can't ping between switches, is there some settings I am missing?

This is what the settings on the port are

Port State            Enable        PVID                  1


                   


Flow Control          Disable               Link Type             Trunk


              


MDI                   Auto                  Speed                 1000


          


Duplex                Full                  Max MAC Count         No Limit


            


Jumbo Frame           Disabled              Port Isolate          Disabled


            


Broadcast Suppression 3000(pps)

thanks

This message was edited by shaunall on 6-29-10 @ 12:50 PM

[shaunall]

When I plug in the trancievers the switches displays a messages indicating it being plugged in, so I assume those are working. (I have also tried other transcievers to eliminate them as the problem). The port condidtion changes from up to down when I unplug the fiber so I know there must be a signal. I configured both ends as trunks and permitted all vlan traffic. Still I am unable to ping between switches. What am I missing?

This message was edited by shaunall on 6-29-10 @ 12:49 PM