HPE Community
Comware Based
1820879 Members
3577 Online
109628 Solutions
New Discussion

H3C 5500 Factory Default

 
Robturn
New Member

‎05-05-2011 03:43 AM - last edited on ‎11-26-2013 06:27 PM by

‎05-05-2011 03:43 AM - last edited on ‎11-26-2013 06:27 PM by

H3C 5500 Factory Default

Hi,
Does anybody know if there is a way to reset an H3C 5500 back to factory default config.

Thanks

 

P.S. This thread has been moved from  Switches, Hubs, Modems (Legacy ITRC forum) to  Comware-Based. -HP Forum Moderator

0 Kudos
1 REPLY 1
Jeff Carrell
Honored Contributor

‎05-05-2011 05:07 AM

‎05-05-2011 05:07 AM

Re: H3C 5500 Factory Default

[5500]reset saved

hth...Jeff

ps, Get this CLI ref guide, it shows how to configure HP ProVision, HP Comware5 and Cisco switches for lots of different functions, in a side-by-side comparison, so if you know one CLI, you see how to do it in a different CLI:

http://h17007.www1.hp.com/docs/interoperability/Cisco/HP-Networking-and-Cisco-CLI-Reference-Guide_June_10_WW_Eng_ltr.pdf
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.