HPE HRS 8600 comware router static route issues

[AmritGupta]

at HPE HRS 8600 comware router

when i configured static route and save it successfully .......its works fine and ok....,

after 24 hours approx some route will removes .

After executing ,"display current diff "

output shows    

- static route syntax for these remove static route 

                      please explain the issues possible causes.

thanks in advance

[Ivan_B]

Hello @AmritGupta !

Sorry, but it's hard to understand what is the issue with your HSR6800. Could you illustrate the issue with the following:

1. Output from 'display ip routing-table' and 'display current-config | in static' while the static route is working
2. Output from the same commands while it stopped working.

Just FYI that 'display current diff' shows you differencies between 'current-configuration' and 'saved-configuration', so if you set the route so it appears in the current-config it will stay there. There is a potential issue that if you reboot the router and the current-config is not saved, then after the reboot that route will disappear. Are you sure that's not the root cause for that route disappearance?