HPE Community
Comware Based
1753797 Members
7237 Online
108799 Solutions
New Discussion

Re: irf member isseu

 
niwai0328
New Member

‎07-02-2017 12:14 PM

‎07-02-2017 12:14 PM

irf member isseu

Hi 

I have HP comware 5510 Two Switches. I configured Irf in both switch. when I configure irf member and priority there was a mistalke with member numbers in both switches. So now I wanted to remove the irf configuration but unfortunatly I couldn't delete the "irf member X priority XX" statment from the switch.

 

I have tried with so many undo cmds. Finaly I was erase my statrup config. But the thing is same. The irf member priority statment is not deleting. any one has a experianced ?

0 Kudos
1 REPLY 1
HP-Browniee
Respected Contributor

‎07-06-2017 01:12 AM

‎07-06-2017 01:12 AM

Re: irf member isseu

Hello

You should not undo this command but renumber it back to 1.

 

Kind regards

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.