Comware Based
1748036 Members
4971 Online
108757 Solutions
New Discussion юеВ

Re: Switch fallback configuration after an false command

 
ahuser
Occasional Contributor

Switch fallback configuration after an false command

Switch fallback configuration after an error

Hi,

when i put an false command from remotely and because of this I lost the the link to the switch. It is possible the device reset automaticly my command?

Regards Andreas

 

P.S. This thread has been moved from ProCurve / ProVision-Based to  Comware-Based. -HP Forum Moderator

3 REPLIES 3
Vince_Whirlwind
Trusted Contributor

Re: Switch fallback configuration after an false command

Yes, before issuing the false command, you issue the "reload in 5" command and it will reload itself into its saved config 5 minutes afterwards.

ahuser
Occasional Contributor

Re: Switch fallback configuration after an false command

many thanks, but it's only for procurve switches right? I have HP (H3C) 5120, 5500, 5800 EI.

Regards Andreas

Vince_Whirlwind
Trusted Contributor

Re: Switch fallback configuration after an false command

"schedule reboot delay 5"