HPE Community
Comware Based
1753331 Members
5308 Online
108792 Solutions
New Discussion

Switch fallback configuration after an false command

 
ahuser
Occasional Contributor

‎11-25-2013 01:56 AM - last edited on ‎09-21-2014 05:10 PM by

‎11-25-2013 01:56 AM - last edited on ‎09-21-2014 05:10 PM by

Switch fallback configuration after an false command

Switch fallback configuration after an error

Hi,

when i put an false command from remotely and because of this I lost the the link to the switch. It is possible the device reset automaticly my command?

Regards Andreas

 

P.S. This thread has been moved from ProCurve / ProVision-Based to  Comware-Based. -HP Forum Moderator

0 Kudos
3 REPLIES 3
Vince_Whirlwind
Trusted Contributor

‎11-25-2013 05:04 PM

‎11-25-2013 05:04 PM

Re: Switch fallback configuration after an false command

Yes, before issuing the false command, you issue the "reload in 5" command and it will reload itself into its saved config 5 minutes afterwards.

0 Kudos
ahuser
Occasional Contributor

‎11-25-2013 05:30 PM

‎11-25-2013 05:30 PM

Re: Switch fallback configuration after an false command

many thanks, but it's only for procurve switches right? I have HP (H3C) 5120, 5500, 5800 EI.

Regards Andreas

0 Kudos
Vince_Whirlwind
Trusted Contributor

‎11-26-2013 02:42 PM

‎11-26-2013 02:42 PM

Re: Switch fallback configuration after an false command

"schedule reboot delay 5"

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.