Terminal length 0

[Pluang]

Hi everyon 

When i try is to show log on sw (someone)  I typing #terminal lengt 0 for complete to sh log

but on hpe how to typing on same this whem i #dis logbuffer re  

[akg7 · Accepted solution]

Hello ,

By default, up to 24 lines can be displayed on a screen. You can change the limit by using the screen-length screen-length command.
You can also disable pausing between screens of output for the current session. Then, all output is
displayed at one time and the screen is refreshed continuously until the final screen is displayed.

Use below command:

HPE# screen-length disable

Thanks!

[Ivan_B]

Hi @Pluang !

Also, you can make this change permanent by adding 'screen-length 0' to 'line vty ...' settings.

<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0] screen-length 0

If you have range of vty, use 'line vty 0 <last_vty_number>', so this option to affect all VTY interfaces.

[Pluang]

Thank you so mush akg7 &  Ivan_B for good suggesstion