HPE Community
Disk Enclosures
1849815 Members
1951 Online
104044 Solutions
New Discussion

Re: 4250 Storage works problem

 
Alan Twigg
New Member

‎04-14-2003 12:28 PM

‎04-14-2003 12:28 PM

4250 Storage works problem

I have a 4250 storage works enclosure ( 2 scsi ch x 5 disks in each ch ) I have an EMU & Duplex I/O module.
The problem is I cannot "see" disks on one of the scsi channels until the EMU is removed !
When the EMU is removed all seems ok

I have swapped scsi cables , psu's etc but its always the disks on the same channel that I cannot detect. I have replaced the EMU but the fault remains.
I am assuming a harware fault as it has worked correctly in the past but which component would seem to be the best bet ?
0 Kudos
Reply
1 REPLY 1
Terry Hutchings
Honored Contributor

‎04-15-2003 06:22 AM

‎04-15-2003 06:22 AM

Re: 4250 Storage works problem

Do you have anything plugged into the back of the EMU?
The truth is out there, but I forgot the URL..
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.