- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Controller Reporting good drives as Bad, why
Categories
Company
Local Language
Forums
Discussions
Knowledge Base
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Knowledge Base
Forums
Discussions
- Cloud Mentoring and Education
- Software - General
- HPE OneView
- HPE Ezmeral Software platform
- HPE OpsRamp
Knowledge Base
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2014 11:30 AM - last edited on 02-02-2014 06:12 PM by Maiko-I
02-01-2014 11:30 AM - last edited on 02-02-2014 06:12 PM by Maiko-I
Controller Reporting good drives as Bad, why
Hi All,
I running a msa 60 connected to a sa-P800 raid controller.
Recently, the controller has tagged a couple of drives as being bad.
So I replaced the drives with new and ran diagnostics on the reported bad drive and it passes the testing.
Why would the controller report the drive as failed when it's not?
btw: these are 2 tb sata drives wd re4
P.S. This thread has been moevd from Disk to Disk Array. - Hp Forum Moderator