HPE Community
Disk Enclosures
1850442 Members
3147 Online
104054 Solutions
New Discussion

Re: Failed disk in Ra 3000

 
shashang
Occasional Advisor

‎08-13-2005 12:04 AM

‎08-13-2005 12:04 AM

Failed disk in Ra 3000

hello all,
I have a failed disk in RA 3000. It consists of two units (one is expansion unit). There are two virtual disks configured, U00 and U01, the failed disk is in U00 (in the expansion unit) and its state is reduced as the controller has not failed over the failed disk's data to the spare disk. But the problem is that in SWCC I can see U01 also in reduced state where as in its properties all its member disks are shown in good condition. Neither do I see the amber LED on any of its disk. What can be the reason for this? Also I am going to change the failed HDD soon so will it be affected in any way?
0 Kudos
Reply
1 REPLY 1
Sameer_Nirmal
Honored Contributor

‎08-16-2005 11:42 AM

‎08-16-2005 11:42 AM

Re: Failed disk in Ra 3000


Can you provide array configuration details here ?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.