HPE Community
Disk Enclosures
1753546 Members
5640 Online
108795 Solutions
New Discussion

MDS600 Flashing LED errors

 
David Birkett
Occasional Contributor

‎01-19-2011 09:07 AM

‎01-19-2011 09:07 AM

MDS600 Flashing LED errors

I have an MDS600 connected via a P812 to a DL385G7. I can't see the disks within the MDS600. Unfortunately I am remote from the device and unable to get to it fir two more days. A member of staff on site has said that the LEDs on the Fans at the rear are flashing amber. The fans are located on the same side of the MDS600 that contains all of the disks (they are all in the same drawer)
I'm throwing out ideas here but imagine that the two must be linked, is it possible that the drawer hasn't been closed properly after someone opened it?
Is there a resource I can use to look up likely causes of the flashing LEDs, everything I have seen so far simply says "fault" not terribly helpful!

TIA

David
0 Kudos
1 REPLY 1
David Birkett
Occasional Contributor

‎02-21-2011 02:43 AM

‎02-21-2011 02:43 AM

Re: MDS600 Flashing LED errors

The cabling configuration was incorrect on the P812 in the server
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.