HPE Community
Disk
1845937 Members
5003 Online
110250 Solutions
New Discussion

3rd SCSI HD installation

 
ChuanH
Regular Advisor

‎03-12-2004 02:07 PM

‎03-12-2004 02:07 PM

3rd SCSI HD installation

Dear all,

I am new with the unix system and really need your help now.

I have a hp9000 c360 workstation with 2 4.5G 3.5" 68-pin Ultra-wide SE drives (A is using, B is not been used), the system was running fine. I got the 3rd 9G HD (C) today and I tried to install C into my system, however I get problems now: the system seems only recognize 2 of them. When I have A, B, C installed, system recognized A & B. When I have A & C, system recognized A & C, when I have A & B, system recognized A &B.
Is it the limitation of the system?
Do I need to do some jump like IDE HD?

Thank you very much for your advise!

Hong

Knowledge is Power
0 Kudos
2 REPLIES 2
e4services
Honored Contributor

‎03-13-2004 11:33 PM

‎03-13-2004 11:33 PM

Re: 3rd SCSI HD installation

SCSI ID needs to be set. (C)the same ID as (B) probably
Hot Swap Hard Drives
0 Kudos
ChuanH
Regular Advisor

‎03-14-2004 05:27 AM

‎03-14-2004 05:27 AM

Re: 3rd SCSI HD installation

Thank you for your reply!

Could you tell me the procedure to assign the device ID?

Thanks,

Hong
Knowledge is Power
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.