Flt--35 on SC10

[Mike Miller_8]

After replacing the failed 36 GB HD in an SC10 with a good tested disk I'm getting a Flt--35 error from stm. After the disk was replaced the LUN went into rebuild mode but then failed. The replacement disk was tested prior to replacement.

From amdsp : (for the failed disk)

SCSI Channel:ID = 2:1
Enclosure = 0
Slot (0-based) = 2
Disk State = NO RESPONSE
Disk Group and Type = 067E8800104BD072A3 LUN
Capacity = 0.0 GB
Manufacturer and Model = NO_VENDOR NO_MODEL
Serial Number = NO_SERIAL_NUM
Firmware Revision = NO_FW_REV

Does this mean that the slot in the SC10 is bad ? Does anyone know what Flt--35 means ?

[Patrick Wallek]

It is possible that the slot is bad. The fact that no information for the disk is showing up not a good sign. Do you have another disk you can try?

[Torsten.]

Is this disk part of an FC60?

[Mike Miller_8]

I don't have another disk to try with yet.

Yes the SC10 is part of an FC60.
There are two other SC10's in the array and they appear to be working fine.

[Torsten.]

Could you please post

# amdsp -a

[Mike Miller_8]

I replaced the drive again and it's now in rebuild mode. Not quite sure if the new drive was having issues or if the slot is having issues. I will close the ticket if the rebuild is successful or post the amdsp -a report if it is not. Should know in an hour or two.

[Mike Miller_8]

Turns out the replacement drive must have been bad. The rebuild worked.

Thanks to those who took the time to respond.

[Mike Miller_8]

Replacement drive to the failed drive was also bad. Second replacement drive worked.