1830655 Members
9644 Online
110015 Solutions
New Discussion

Re: Hot swap problem

 
Ayman Altounji
Valued Contributor

Hot swap problem

Each time the client hot swaps a FW drive PN 199598-001 with a newer Wide Ultra drives PN 242622-001 CIM indicates the drive as being degraded. The systems they are doing the upgrade on are a Proliant 4500 internal storage and 2 external storage boxes one being a F1 box and the other being a UE box both connected to a Proliant 5500. I didn?t believe that all the drives were truly in a degraded state even though the drives that thay were using were used drives with about 20000 hours of drive time on them. It was recommended that I upgrade the ROM on the drives. After upgrading the drives (Aprox. 25% of the drives took the update) they tested degraded still. The next step I took was to built a test box (Proliant 5500) with external storage attached (U2 box) and test all the drives to make sure that the drives were in a good state. I tested approx. 100 drives and sorted the good from the bad but even the tested known good ones could not be swopped on the production unit. I also want to mention that the difference with the drives are that the older FW drives do not have S.M.A.R.T. (Self-Monitoring Analysis and Reporting Technology). At this point I am pretty stumped on this issue, it seems there is a problem with the to types of drives being mixed on the backplane at the same time. I have reproduced the issue on the test box. (Additional info) S/N of UE box D841CDB10334 - Agent level is 4.5 on the servers ? CIM level is 4.21 ? Win NT 4.0 SP4 ? S/N Proliant 4500 6550HRX20249 ? S/N Proliant 5500 D848CCT20036

Thanks
5 REPLIES 5
Ayman Altounji
Valued Contributor

Re: Hot swap problem

What controller are you using with the drives? You can NOT hot-plug drives if you do NOT have an array controller so...
Ayman Altounji
Valued Contributor

Re: Hot swap problem

Controller is a Smart 3200. Rom level 4.32.
Ayman Altounji
Valued Contributor

Re: Hot swap problem

on
Little update CIM version is now 4.9. Please respond.
Ayman Altounji
Valued Contributor

Re: Hot swap problem

Do you know what firmware is in use on these drives? Also, since the 4500 can't possibly have a 3200 array controller (no PCI slots) do you know what controller that system has (had)?
Ayman Altounji
Valued Contributor

Re: Hot swap problem

The 4500 had a 2DH controller.