HPE Community
Disk
1831645 Members
3334 Online
110029 Solutions
New Discussion

Power Light not powered on

 
Ayman Altounji
Valued Contributor

‎02-25-2001 04:00 PM

‎02-25-2001 04:00 PM

Power Light not powered on

I do not have any power lights on my Hotswap drives. It has to be a software issue. If I reinstall from scratch through smartstart it works fine. I just want to get them to work after the install.
0 Kudos
3 REPLIES 3
Ayman Altounji
Valued Contributor

‎03-18-2001 04:00 PM

‎03-18-2001 04:00 PM

Re: Power Light not powered on

I have an array that has working drives in it, I am able to browse the drives but I get no Power LED. I get Activity LED but no Power LED.
0 Kudos
Ayman Altounji
Valued Contributor

‎03-27-2001 04:00 PM

‎03-27-2001 04:00 PM

Re: Power Light not powered on

Try updating the System ROM of the Servers along with the firmware of the Smart Controllers and drives . If still no LEDS on drives have the pluggable backplane replaced .
0 Kudos
Ayman Altounji
Valued Contributor

‎08-12-2001 04:00 PM

‎08-12-2001 04:00 PM

Re: Power Light not powered on

Try updating the System ROM of the Servers along with the firmware of the Smart Controllers and drives . If still no LEDS on drives have the pluggable backplane replaced .

I have upgraded the ROM, still no lights. I am not running any Smart Controllers only the on board controllers. Is there anything else to upgrade before I replace the backplane? I have two brand new Proliant 6500 servers and they both respond the same....I don't believe that both can have a bad backplane.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.