HPE Community
Disk
1832973 Members
2694 Online
110048 Solutions
New Discussion

Re: SETUP of drive

 
Ayman Altounji
Valued Contributor

‎01-24-2001 04:00 PM

‎01-24-2001 04:00 PM

SETUP of drive

I brought the SCSI hard drive S/H 4.3GB DDRS-34560W. Upon trying to setup found that the drive only showed 1048MB but the adaptec AHA-2842VL controller showed 4094MB operating system windows 98. I would like to now the cylinders, heads, & sectors so I can set it up using ranish partition manager, but if anybody can help I would be most greatful.
0 Kudos
1 REPLY 1
Ayman Altounji
Valued Contributor

‎02-06-2001 04:00 PM

‎02-06-2001 04:00 PM

Re: SETUP of drive

You can not configure a SCSI driver like it was IDE... Since the controller DOES see the full capacity (formatted is ALWAYS less than the rated capacity) it's not the drive's fault.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.