HPE Community
Disk
1825002 Members
2756 Online
109678 Solutions
New Discussion

What's the problem

 
Ayman Altounji
Valued Contributor

‎07-18-2001 04:00 PM

‎07-18-2001 04:00 PM

What's the problem

When I connect the drive to a functioning SCSI controller I either get Star Unit failed or Drive connected not ready. Depending on where the motor jumper is set. It's an 18.2 Not-Pluggable drive that was only unboxed and opened on 7/18 Is this a bad drive? I can connect other Ultra 2 drives and they work fine. Model number is 328943-b21
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.