- Community Home
- >
- Storage
- >
- Legacy
- >
- General
- >
- HSG80 ECB problem
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2004 08:17 PM
06-13-2004 08:17 PM
HSG80 ECB problem
On a HSG80 i recenty had an ECB replacement.
After the replacement, every 24 hours , the SWCC sends out an e-mail saying the battery is low and within 7-8 minutes, it reports the battery as "Good" again.
Just wondering, if anything could be done to rectify this.
Thoughts please.
Thanks
Srivathsan
- Tags:
- battery
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2004 09:37 PM
06-13-2004 09:37 PM
Re: HSG80 ECB problem
If not that may explain your problems, on the other hand you may have a 'bad' new battery.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2004 09:42 PM
06-13-2004 09:42 PM
Re: HSG80 ECB problem
We did go through the proper replacement procedure.
One thing that you mentioned , setting the battrey time, was not done.
Could you please add more on this..are u referring to setting the controller time..is that supposed to cause this behavior.
Thanks in advance
Srivathsan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2004 09:49 PM
06-13-2004 09:49 PM
Re: HSG80 ECB problem
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2004 09:52 PM
06-13-2004 09:52 PM
Re: HSG80 ECB problem
It would be great if you could let me know the command and gotchas if any in using it.
Thanks in adnvance.
Srivathsan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2004 10:04 PM
06-13-2004 10:04 PM
Re: HSG80 ECB problem
I think that the frutil command is what sets the time and discharge history on the new batteries. I got my wires crossed with the set this_controller date xxx-xxx-xxx,etc.
but the forum post on this link below would seem to concur that the frutil is what should set the date on the batteries. Have a look at the post and see if this is what happened when you ran frutil, also run a show this_controller full and have a look right at the bottom of the output and check that the date on the expiry of the battery is a reasonable date in the future, I think it is normally around a year in advance of the current date. If its not then maybe you will have to run frutil again on either a new battery or the same one.
HTH
regards
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=564290
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2004 10:22 PM
06-13-2004 10:22 PM
Re: HSG80 ECB problem
Thanks a lot for your help.
Regards,
Srivathsan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2004 02:26 PM
06-14-2004 02:26 PM