- Community Home
- >
- Networking
- >
- IMC
- >
- IMC switch config backup fail when stacked switch
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2018 07:11 AM - edited 04-20-2018 07:16 AM
04-20-2018 07:11 AM - edited 04-20-2018 07:16 AM
IMC switch config backup fail when stacked switch
I have a problem with IMC only when I try backup config in switches stacked and specific models.
Error mesage:
SNMP Set operation failed.
1. Check that the SNMP parameters are correct. With SNMPv3 adopted, the username, authentication password, privacy password and privacy mode for the device and the iMC should be the same.
2. Check the MIB style (Execute the display mib-style command. If the MIB style is displayed as new, but it displays that the node sending the Set request is 2011 after packet capturing, synchronize the device. Check the MIB style again. If the MIB style is still inconsistent, execute the mib-style [ new | compatible ] command, and then restart the device.).
3. Error code such as no such name may occur for the Set operation. You need to capture packets to analyze whether such error occurs in the response received by the device.
4. Device busy, please retry later.
But I test the snmp and telnet credentials with success.
The switches model: 3COM 4500, 5500G
I had others switches the same model and firmware version, but non-stacked, the backup works successfully.
I had the switch model HP3600-48 POE stacked, the backup works successfully.
Thanks for any help