Emulex LP9802 not found

[squirrel_2]

Hi everyone,

I have an Emulex LP9802, an rx5670, HP-UX 11.31 and problems getting the FC controller to work.

I installed driver version 6.00.05 from the Emulex page and the kernel module is loaded:
-----------------
# kcmodule -v lpfc
Module lpfc (6.0)
Description Emulex LightPulse Fibre Channel Driver
Timestamp Fri Jul 18 23:44:41 2008 [48810EC9]
State loaded (via autoload)
State at Next Boot auto (as requested)
Capable auto static loaded unused
Depends On interface HPUX_11_31_PERF:1.0
-----------------

Both utilities don't find the adapter:
-----------------
# /opt/lpfc/bin/showhba
Found No Adapters
# /opt/lpfc/bin/lputil
Found No Adapters
-----------------

"ioscan" shows the controller as
fc 1 0/2/1/0 UNCLAIMED UNKNOWN Emulex LP9802

The LED on the controller is blinking green.

What is going wrong here?

Thanks in advance!

[squirrel_2]

UPDATE:

During shutdown the following messages appear:

Loading Emulex LPFC Driver Release 06.00.05
lpfc1: *** ERROR cannot map SLIM address 0x0-a0041000
lpfc1: fc_attach: Adapter init failed. Adapter remain offline 1 0 0 0
wsio_claim init failed isc=0xe000000150e12c00 name=lpfc
hpvmdvr: handle=0xe0000003a9410080
hpvmdvr: vector=0x00000000000000d4
(hpvmdvr) hpvmdvr_load=0xe0000003adc253e0
hpvmntdvr_install successful (hpvmntdvr_install=e0000003a949b8a0)
lpfc1: *** ERROR cannot map SLIM address 0x0-a0041000
lpfc1: fc_attach: Adapter init failed. Adapter remain offline 1 0 0 0
wsio_claim init failed isc=0xe000000151690c00 name=lpfc
lpfc1: *** ERROR cannot map SLIM address 0x0-a0041000
lpfc1: fc_attach: Adapter init failed. Adapter remain offline 1 0 inquiry page 83h/80h failr the current page 83h/80hdata do not match the prev known page 83h/80h data oth, instance = 3) The lun is (class = lunpath, inste 7).Run 'scsimgr replace_wid' command to validate t The lun path is (class = h, instance 7).Run 'scsimgeplace_wwid' command to vadate the change

classnpath, instance 7
Evpd i existing LUN id 0x400400000000000 failed with errnoof 14.

[Noemi Llano]

Hello,
I know you had this problem last year,but, did you solved it?
I have the same problem as you, with Emulex LP9002. I installed driver version 6.00.05 and kernel module is loaded.
Thanks.
Noemí

[squirrel_2]

Hi,

I was unable to solve my problem with this adapter.
IIRC the problem was that the adapter was EMC-labeled.

So neither Emulex nor HP wanted to provide support.

I thought about buying an LP10000, but I didn't do it yet.