How config SmartArray 6402 RAID Controller

[VICBUR1507]

Hi mates!

I have a rx4640 with two internal disk 146 Gb U-320, configured in mirror for SmartArray 6402 RAID Controller. I need unconfigure this, because I need this second disk for virtualization propuses, anybody know how can I do this??? (unconfigure this raid 1+0).
I try whit saconfig but said that the device 0 is currenty in use.

Thanks Mates.

Regards,

VB

[VICBUR1507]

sbserc25:/tmp> saconfig /dev/ciss2

******************** SmartArray RAID Controller /dev/ciss2 ********************

Auto-Fail Missing Disks at Boot = disabled
Cache Configuration Status = cache enabled
Cache Ratio = 50% Read / 50% Write

---------- PHYSICAL DRIVES ----------

Location Ch ID Size Status

Internal 1 1 146.8 GB OK
Internal 2 0 146.8 GB OK

---------- LOGICAL DRIVE 0 ----------

Device File = c2t0d0
RAID Level = 1+0
Size = 140006 MB
Stripe Size = 128 KB
Status = OK

Participating Physical Drive(s):

Ch ID

1 1
2 0

Participating Spare Drive(s):

None

[smatador]

Hi,
Better way is to reduce this disk in the vg.
After that you could remove it by
saconfig /dev/ciss2 -D 0
check the doc
http://docs.hp.com/en/J6369-90074/J6369-90074.pdf
Hope it helps

[Torsten.]

IMHO you can only delete the existing RAID (offline) - you will loose all the data - and create 2 RAID 0 logical drives.

[Torsten.]

You can also try a RAID migration - make sure you have a good backup!

# saconfig /dev/cissX -M -R