HPE Community
Integrity Servers
1848375 Members
3306 Online
104025 Solutions
New Discussion

NVRAM issue while installing windows2003IA 64

 
sathyamoorthy
Occasional Advisor

‎12-29-2008 10:21 PM

‎12-29-2008 10:21 PM

NVRAM issue while installing windows2003IA 64

Hi
i am using RX6600 and RX3600 server.i installed windows 2003IA64 OS in these servers.If i have converted OS logical driver in Basic mode to Dynamic mode, the system asking two reboots but after second reboot,the OS did not come up.
i have observed following error message.
" Hi
i am using RX6600 and RX3600 server.i installed windows 2003IA64 OS in these servers.If i have converted OS logical driver in Basic mode to Dynamic mode, the system asking two reboots but after second reboot,the OS did not come up.
i have observed following error message.
"Windows could not start because there was an error reading the boot settings from NVRAM. Please check your firmware settings. You may need to restore your NVRAM settings from a back up "
PLEASE CONSIDER THIS ONE AS HIGH PRIORITY!!!
NOTE:i updated latest ROMBIOS for server and latest Firmware for SAS HBA.
Please find the screen shot also."
PLEASE CONSIDER THIS ONE AS HIGH PRIORITY!!!
NOTE:i updated latest ROMBIOS for server and latest Firmware for SAS HBA.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.