HPE Community
LAN Routing
1819870 Members
2616 Online
109607 Solutions
New Discussion

HP and switch link aggregation

 
mudvayne15
Occasional Contributor

‎09-05-2019 06:32 PM

‎09-05-2019 06:32 PM

HP and switch link aggregation

Hi everyone,

I am setting up a lab with an HA Fortigate and a switch. 

I set the Fortigate's Port 1 and 2 as aggregate and I made 2 ports on the switch in LACP. 

However on the switch, it is always blocked by LACP and I coudn't find a way to resolve this. I am already using rstp on the switch. 

0 Kudos
1 REPLY 1
parnassus
Honored Contributor

‎09-06-2019 12:50 AM

‎09-06-2019 12:50 AM

Re: HP and switch link aggregation

Can you share the show lacp and show trunk HP Switch CLI commands' outputs? Are you sure that on Fortigate side the port aggregation you configured is correctly defined as IEEE 802.3ad (LACP)? RSTP doesn't interfere with a properly defined Port Trunk (port aggregation).


I'm not an HPE Employee
Kudos and Accepted Solution banner
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.