HPE Community
Netservers
1847127 Members
5731 Online
110263 Solutions
New Discussion

Adapter Teaming Windows 2000

 
Keith Harro
Occasional Contributor

‎05-28-2002 12:37 PM

‎05-28-2002 12:37 PM

Adapter Teaming Windows 2000

I recently upgraded from NT4.0 to Win2000 on an Netserver LH4. I have dual HP NIC's and did have adapter teaming up and running. I no longer see the adapter teaming option in the HP Set in Control Panel. The NIC drivers upgraded OK during the win2000 upgrade. I installed the HP ProSet II software but still can't find how to set it up again. Thanks!
0 Kudos
2 REPLIES 2
Chris Blumenshine
Trusted Contributor

‎05-28-2002 12:45 PM

‎05-28-2002 12:45 PM

Re: Adapter Teaming Windows 2000

In ProSet II, right click on an adapter you want to team. From the menu that pops up, you should get the option to add to team -> create new team.
There's always room for J-E-L-L-O
0 Kudos
Keith Harro
Occasional Contributor

‎05-29-2002 10:46 AM

‎05-29-2002 10:46 AM

Re: Adapter Teaming Windows 2000

Chris: Thanks! When I rt clicked on one of the adapters, nothing happened. So, even though the Win2000 upgraded the NIC drivers successfully, I went ahead and did the UPDATE DRIVER and installed the latest driver from hp.com Then, when I ran the PROSET II, I was able to create a team. As you probably know, the server fails for a few seconds, oops, my bad! I went to NETWORK PROPERTIES, saw a third Network connector. I reconfigured the IP, Gateway, DNS, etc, and all is well. Thanks!
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.