HPE Community
Netservers
1857320 Members
8132 Online
110372 Solutions
New Discussion

Re: Boot Order

 
Ivan Stretten
Occasional Contributor

‎02-14-2003 03:13 AM

‎02-14-2003 03:13 AM

Boot Order

I have an E800 with 2 disks on a Netraid controller ID's of 7, and a dat drive on the SCSI a channel with an ID of 3, I want to repvae that dat drive with a scsi hard disk with and ID of 3,When I rebbot the server I get" OPERATING SYSTEM NOT FOUND" How do I change the boot order so that it does not try to boot off the hard disk on the SCSI A channel, I want it to boot off the disks on the Netraid controller, as it normally did with the dat drive in place.
0 Kudos
1 REPLY 1
Ivan Stretten
Occasional Contributor

‎02-14-2003 09:23 AM

‎02-14-2003 09:23 AM

Re: Boot Order

Found the answer by going into the configuration utility F2, and changing the boot order there
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.