Disk Raed Error - LH Pro

[Anthony Amorteguy_1]

I am trying to reinstall Win2k Ad. Serv. on a LH Pro and on reboot to complete the install I get:

A disk read error occurred

The spicifics are these:
Dual 200 Pros
4 x 9Gb set raid 5
2 x 4Gb set raid 1
588Mb RAM

I have run all diagnostics and all complete with no errors.

I am using an IDE CDRom because the SCSI CDRom failed.

I am installing off the boot disks and it completes the installation preparation just fine. It loads the installation files, partitions and formats the drives without problem or errors.

Once preparation is done, it is rebooted to complete and I get the disk read error.

Any ideas?

[Theo Hill_1]

Are you sure you have the system configured to boot to the correct drives? The netraid and netraid-1 are not supported in win2k, are you using either of these netraid controllers?

[Anthony Amorteguy_1]

Thanks for the repsonse. I'll look into that.

I didn't look at some of the hardware configurations as this is not a new installation, but a reinstallation of Win2k.

I'll post the information as I find out those details.