HBA NetRaid 1M Issue

[Uwe Kreckler]

I have trouble with NetRaid-1M Controller as following:
I built this controller in several desktop machines, but after system start I can't go into HP NetRaid Express Tool with "Ctrl-M".
The key input is accepted, but the tool isn't starting after POST routine. When I using the HP NetRaid Assistant DOS disk to configure raid devices, all is OK. Also the results of diagnosis with the HP NetRaid Assistant disk are OK. Firmware of HBA is also the newest. Where is the problem? Can somebody help me?
Sorry for my bad english.
Thanks and Best regards
Uwe Kreckler

[Bryan Eley]

This may not be quite the same as what you are experiencing...but have you seen either of these threads?

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=916212

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=645054

Regards,
Bryan

[Uwe Kreckler]

Hallo, thanks.
I changed the HBA and now all is working fine on each system. There was something with the controller.
Regards
Uwe Kreckler

[Uwe Kreckler]

Hallo, thanks.
I changed the HBA and now all is working fine on each system. There was something with the controller.
Regards
Uwe Kreckler